|
|
|
#1
|
|||
|
|||
240d/300d injection pump caps
hello, i was wondering if anyone knew where to purchase the bosh injection pump caps that go on top of the pump when the hardlines are removed (to make sure dirt and whatnot do not get in them.
thanks. |
#2
|
|||
|
|||
Any injection pump repair shop. Or perhaps small balloons necks could be stretched over?
|
#3
|
|||
|
|||
__________________
78 W116 300SD 'Desert Rose' new as of 01/26/2014 79 W116 300SD 'Stormcloud' RIP 04/11/2022 |
#4
|
|||
|
|||
Quote:
is there a correct size for the OM616 and 617 injection pumps? |
#5
|
|||
|
|||
Quote:
I'm not sure of the size of the oil feed banjo bolt, it is smaller though. Take a lug bolt, which also has M12 X 1.5 threads, with you to the store for sizing of the tapered plastic caps. You could use M12 X 1.5 acorn style lug nuts as caps for the delivery valves. For temporary use you could cut the fingers off of a nitrile glove to use as covers for the delivery valves.
__________________
78 W116 300SD 'Desert Rose' new as of 01/26/2014 79 W116 300SD 'Stormcloud' RIP 04/11/2022 |
#6
|
|||
|
|||
When I cut off the ends of the Hard Lines I got from PNP. Then you have the ball end and the Cap Nut to close off the IP or the Injectors.
File the ends smooth and plug the hole with JB Weld or??? Charlie
__________________
there were three HP ratings on the OM616... 1) Not much power 2) Even less power 3) Not nearly enough power!! 240D w/auto Anyone that thinks a 240D is slow drives too fast. 80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works |
#7
|
|||
|
|||
thanks. I will stop by ssf next weekend to pick those up.
|
Bookmarks |
|
|