W123 300TD Hatch Washer Nozzle...



I'm installing a new washer hose and I cannot get the hose back on with the nozzle installed in the Hatch. So, I need to *properly* remove the Washer Nozzle (without damaging it)... and, I cannot figure out how to do it.


I've culled tech docs etc and cannot find any instructions...


Any and all assistance regarding this is *greatly* appreciated!!!


Thanks in advance!!!


dennis

__________________
'84 300D (211k) *New*... (Wife's)
'85 300TD (174K) 10th Year... (Mine)
'96 F-350 7.3L Dually (149K) Since New
'85 300D (156K) ~~~Wrecked~~~ Damn it! (parts)
'84 300D (176k) ~~~Wrecked~~~ Damn it! (parts)

Subscribed .

__________________
-Nate
1982 240D 408,XXX miles
Ignorance is the mother of suspicion and fear is the father

I did then what I knew how to do ~ now that I know better I do better

Picture? Is it like the hood nozzles? I squeezed the tabs inward on those to remove from the underside of the hood.

https://www.youtube.com/watch?v=G475vk45j1A

Thanx for the link ~ I didn't know about the check valve .

Most often the problem is old wax clogging up the sprayer nozzles, easy to clean out using a very thin bit if very stiff wire ~ I yank a bristle out of my big wire brush but pins or needles work passably too .

Try that before taking anything apart .

__________________
-Nate
1982 240D 408,XXX miles
Ignorance is the mother of suspicion and fear is the father

I did then what I knew how to do ~ now that I know better I do better

THANK YOU!!!

dennis

__________________
'84 300D (211k) *New*... (Wife's)
'85 300TD (174K) 10th Year... (Mine)
'96 F-350 7.3L Dually (149K) Since New
'85 300D (156K) ~~~Wrecked~~~ Damn it! (parts)
'84 300D (176k) ~~~Wrecked~~~ Damn it! (parts)