|
|
|
|
|
#1
09-13-2002, 07:09 AM
|
|||
|
|||
|
special start
hoping to install oil cooler lines in my 83 300d turbo sometime this weekend. any special starting instructions to insure i have oil pressure once it fires? should i hold the stop and crank for a while? should i remove the glowplug fuze and crank? thank you.
|
|
#2
09-13-2002, 12:17 PM
|
|||
|
|||
|
On older diesels, the oil cooler had a drain plug and I drained it at every oil change. The manual did not specify any special instruction on starting the car after an oil change and I just started it up normally and made sure the oil pressure came up before I revved the engine any. Never had any problems. If you are nervous, crank the engine with someone holding the IP stop lever and wait for oil pressure to register, then stop and start it up like normal. If you are by yourself, crack the injector line nut at each injector to starve the engine from fuel, you will make a little mess, but this will allow oil to flow to the cooler and lines. I know that on the 603 engine, oil is not sent to the cooler until the engine is hot and an oil thermostat opens. If this is the case on your engine, then there really is nothing to be concerned about.
Henry
__________________
63 190d (sold) 69 220D (sold) 69 280SL (sold) 76 BMW 2002 (sold) 86 190E-16v (Demised at Laguna Seca Turn 9) 87 300SDL (sold) 87 300SDL 135k 87 300TD 280k (sold) 95 E320W 311k 95 E320w 180k 05 C320 4matic 06 E320 CDI 90k (Totaled by a texting 19 year old girl in a nissan) 2013 GLK 250 Bluetek 4MATIC 295k
|
 |
| Bookmarks |
|
|
Linear Mode
