|
|
|
|
|
#1
08-08-2003, 06:46 PM
|
||||
|
||||
|
87 300D front fender, lower molding attachment
How do I re-attach this mouding? There are three white clics and 3 pins that lock the clip in the fender hole.
|
|
#2
08-08-2003, 11:07 PM
|
||||
|
||||
|
Go to the dealership and buy 3 new clips. Then slide the clip back on.
__________________
1987 mercedes 300E 1995 e320 conversion(hated the 300e grill) HID/Xenon (D2S) Keyless Entry Monochromatic Paint (Custom Blue) Smoked Tails Flat Badged (front) Debadged (rear) custom "carbon fiber" console 18 inch HP EVO rims Sold! Now I drive a Monte Carlo SS http://memimage.cardomain.net/member.../352975_67.jpg http://memimage.cardomain.net/member.../748335_24.jpg
|
|
#3
08-08-2003, 11:19 PM
|
||||
|
||||
|
Do you mean install the new clips into into the holes in the fender (fender still on car), then slide the molding onto the clips?
|
|
#4
08-09-2003, 12:14 AM
|
||||
|
||||
|
yes! if you try to put the molding on with the old clips, most likely if will fall back off. The same thing happened to me, the 3 clips cost me less than $1 at the dealership!!
__________________
1987 mercedes 300E 1995 e320 conversion(hated the 300e grill) HID/Xenon (D2S) Keyless Entry Monochromatic Paint (Custom Blue) Smoked Tails Flat Badged (front) Debadged (rear) custom "carbon fiber" console 18 inch HP EVO rims Sold! Now I drive a Monte Carlo SS http://memimage.cardomain.net/member.../352975_67.jpg http://memimage.cardomain.net/member.../748335_24.jpg
|
|
#5
08-09-2003, 01:31 AM
|
||||
|
||||
|
Thanks. I''l pick them up tomorrow.
|
 |
| Bookmarks |
|
|
Linear Mode
