I have a 1999 ML320.
Last week replaced the drive shaft bearing.

When looking at things, discovered the ball joint was worn out wil 1/4" of play.
That explains my handling problem and tire wear. The stabilizer bar looked worn too.

So I ordered a new Rear ML320 Ball joint and Special socket.

They arrived ,,,then apon further inspection what I bought was some upper
ball joint. Maybe what I need is a Control Arm Ball Joint. But it appears there is no such thing. Am I forced to buy and replace the whole Left Rear Control Arm as ther ball joint in it is non replacable ?
Thank you.
Steve

__________________
Steve Danville
what i did myself.
CPS
rear shocks
MAS x 3.
SparkPlugs (twice)
Fuel pump & Filter
Window switch
replaced both failed horns with Honda horns.
Cleaned ERG Tube
Oil changes
Oil consumption Fix
Brake Pads
A/C Recharge
Anti-Freeze change X 2.
Front Shocks. Monroe. $90
Mercedes Warrenty Work:
Harmonic balancer,power steering clamp. Cat converters.Drive Shaft Bearing.s
Replaced Outer Lower Tie Rods and front lower ball joints at 156,000 miles

What was the part number?

__________________
MERCEDES Benz Master Guild Technician (6 TIMES)
ASE Master Technician
Mercedes Benz Star Technician (2 times)
44 years foreign automotive repair
27 Years M.B. Shop foreman (dealer)
MB technical information Specialist (15 years)
190E 2.3 16V ITS SCCA race car (sold)
1986 190E 2.3 16V 2.5 (sold)
Retired Moderator