1999 ML rear bumper removal and reinstallation
 

Can anybody tell me how to remove and resinstall the 1999 ML 320 rear bumper. Thanks.
Ken

Sure, it's real easy. First, in the center of the bumper on the bottom edge is the rectangular snap in section where the trailer hitch would pass through. Remove that section, it just pulls off. Then on each side of this (about a foot or two away) are smaller pull out sections. Pry these off also. Inside the large section there are 2 10mm nuts that are removed, and also one each in each of the side panels. Remove those as well. The reast is simple, just pull straight back on the bumper, however at the leading edges on each side there are small hooks (this would be on the side of the bumper, behind the rear wheels). You just need to pull outward slightly in these 2 areas to release the hooks. Simple job.

Gilly

Thanks. Will give it a try.

Gilly
 

Are there any secrets to installing the trailer hitch? (Also, what do you use to cut the center panel around the hitch?) The directions seem easy enough to follow. Thanks, Paul

The mechanicals are all pretty straight-forward. The electrics are a little trickier, let me know if you get hung up on it. I'm not sure if the instructions mention installing a fuse, I think it's #41? Go with what the fuse chart tells you, and at that amp rating also, I think it's a 25a fuse,

Gilly

Thanks.