|
|
|
#1
|
|||
|
|||
17 Mm Crows Foot
Hi All
i have been all over the web searching for this tool. Every one calls me back and says they have discontinued stocking this item due to the cars age 1975 450 sl. I would like to adjust the valves in this car soon Can any one out there help me out Thanks Razorman |
#2
|
|||
|
|||
How about here?
Did you try these guys? High quality and fast service from them!
http://www.samstagsales.com/ By "Crows Foot" do you mean a tool that looks like just the head of an open end wrench with a square drive hole next to it that is to be driven from a ratchet and extention? |
#3
|
|||
|
|||
17 mm crowsfoot
Hi BillyBOB
Yes that is the one i am talking about. Thanks i will call these guys in the morning. Razorman |
#4
|
|||
|
|||
Or!
You can buy a single 17 MM Craftsman Crows Foot at Sears for about $5 if you need it tomorrow!
|
#5
|
|||
|
|||
Howdy Razorman,
Look at the thread "I found the best mechanic tools made" in this forum. There are a number of the tool manufacturers mentined in that thread that should have it. Good luck in your search.
__________________
Frank X. Morris 17 Kia Niro 08 Jeep Wrangler 4 door unlimited |
#6
|
||||
|
||||
I got mine from Baum's Tools
You can get yours too at http://www.baumtools.com/english/specialtools.cfm for about $68.00.
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. |
#7
|
|||
|
|||
This Tool?
Last edited by Billybob; 02-12-2008 at 12:02 AM. |
#8
|
||||
|
||||
Yup, that's the V-8 valve adjustment 17mm crowsfoot (you can tell due to the relief on the bottom side).
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. |
#9
|
|||
|
|||
17 mm crows foot
Thanks Guys
I went to ebay and used buy it now. I did not know that the wrench had that much relief at the bottom. Well i should get this in a few days,i will let you all know how it goes. THANKS All Razorman |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|