Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Showing results 1 to 14 of 14
Search took 0.01 seconds. Search: Posts Made By: Chris Dvorak
Forum: Tech Help 05-30-2007, 01:08 PM
Replies: 4
Views: 854
Posted By Chris Dvorak
It seams that the leak has subsided. But if it...

It seams that the leak has subsided. But if it returns I will get a new pan.
Thanks for the great advice, reducing ones frustration is always greatly appreciated.

Chris
Forum: Tech Help 05-25-2007, 12:45 PM
Replies: 4
Views: 854
Posted By Chris Dvorak
124 trans pan gasket leak

The tranmsission pan has leaked on my 92 400E. I started out with a normal torque of the 6 bolts and it leaked in the passenger rear side of the pan near the drain hole. I then torqued it to about...
Forum: Tech Help 05-21-2007, 04:46 PM
Replies: 7
Views: 1,285
Posted By Chris Dvorak
I made a code reader. There is a cable with...

I made a code reader. There is a cable with numbered pins on the passenger(right) side near the upper strut mount. I am not sure of the pin count on the pins in the black box.

Chris
Forum: Tech Help 05-21-2007, 03:06 PM
Replies: 7
Views: 1,285
Posted By Chris Dvorak
Aurther thanks for your help. I did another ac...

Aurther thanks for your help.
I did another ac voltage test on the passenger side and got the wheel spinning very fast and saw some voltage. The drivers side gives a stonger signal. I was reading...
Forum: Tech Help 05-18-2007, 12:41 PM
Replies: 7
Views: 1,285
Posted By Chris Dvorak
Thanks Arthur for the feed back. I test both...

Thanks Arthur for the feed back. I test both front sensors and checked the ends for magnetic shavings. There was some black dust on the sensor itself and I observed 900 ohms on both front connectors,...
Forum: Tech Help 05-16-2007, 03:57 PM
Replies: 7
Views: 1,285
Posted By Chris Dvorak
92' 400E 124 ABS light

I have a 1992 400E that has the ABS light on as soon you turn the key on.
The research I hve conducted in this forum has lead me to do the following.
1. I checked resistance on both wheel sensor...
Forum: Tech Help 02-08-2007, 04:33 PM
Replies: 2
Views: 833
Posted By Chris Dvorak
There is a control box that failes to function....

There is a control box that failes to function. When my fan stopped working
the culprit was a control box mounted under neath the fan. Difficult to get to on a 124 class. The trip took me two hours...
Forum: Tech Help 02-07-2007, 02:43 PM
Replies: 3
Views: 764
Posted By Chris Dvorak
93 400E(124) washer fluid leak.

This car has two wiper pumps that slide into the washer fluid tank. Each has a rubber grommet that I also replaced. I tried sealing with silicone bathroom caulk. Just can't seal the leak. Any ideas?...
Forum: Tech Help 02-07-2007, 02:26 PM
Replies: 10
Views: 1,750
Posted By Chris Dvorak
I have experienced this several times over the...

I have experienced this several times over the last 4 years. Turn the car off
and restart this has worked for me 6-8 times. It has not done this for over a year. Once the car would not start in the...
Forum: Tech Help 01-17-2006, 03:42 PM
Replies: 10
Views: 1,342
Posted By Chris Dvorak
I have gotten three or more sets of pads on one...

I have gotten three or more sets of pads on one set of rotors. I change pads when the pads are equal the backing. In other words I change at about one third of the pad left. Obviously the width is...
Forum: Tech Help 12-09-2005, 04:24 PM
Replies: 5
Views: 1,472
Posted By Chris Dvorak
93 400E asr light Limp mode

I have read most of the old posts reguarding the ASR light and Limp mode.
My car has had 4 episodes of the ASR variety the last three in the last week or so. It clears out and runs fine after tuning...
Forum: Tech Help 12-09-2005, 03:56 PM
Replies: 6
Views: 981
Posted By Chris Dvorak
I replaced the fan control modual last winter on...

I replaced the fan control modual last winter on my 400E. My fan worked fine.
The plastic screan is not the dust filter. My car did not have the filters.
I think you can the info from the VIN...
Forum: Tech Help 02-16-2005, 06:57 PM
Replies: 5
Views: 1,806
Posted By Chris Dvorak
93 400 e with similar problem

I have similar characteristics but my 15 amp fuse was blown. I have taken out the blower fan which is located about an hour underneath your wndsheild wiper assembley. My fan worked outside the car so...
Forum: Tech Help 02-07-2005, 12:42 PM
Replies: 26
Views: 15,216
Posted By Chris Dvorak
93 400 e with similar problem

My 93 400 E had no fan function it runs fine on the bench. It sounds like it could be the voltage regulator. Where is this located and how is it tested.
How can you tell if your car came with dust...
Showing results 1 to 14 of 14

 
Forum Jump


All times are GMT -4. The time now is 10:08 AM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page