Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Today's Posts Search

Page 1 of 5 1 23 Last »
Showing results 1 to 30 of 121
Search took 0.03 seconds. Search: Posts Made By: slimak9
Forum: Tech Help 10-17-2013, 09:29 AM
Replies: 0
Views: 798
Posted By slimak9
Question Where does the Timing Cover Oil Seal go on 603 motor? # 0129975648

I'm working on a 603.961 motor and am gathering parts for a timing chain & guides job.

I see advertised for sale on pelican parts:
Part # 0129975648 Timing Cover Oil Seal

Does anyone know...
Forum: Tech Help 04-06-2012, 11:08 PM
Replies: 5
Views: 1,575
Posted By slimak9
You're right. I had a chance to check a 1995...

You're right. I had a chance to check a 1995 W140 and it works exactly like my 1993 with only the centre rear dome light iluminating when the rear doors are opened. Meanwhile the 1992 W140 I...
Forum: Car Audio and Multimedia 04-02-2012, 02:44 PM
Replies: 2
Views: 9,142
Posted By slimak9
Pics 10-11

Pics 10-11
Forum: Car Audio and Multimedia 04-02-2012, 02:43 PM
Replies: 2
Views: 9,142
Posted By slimak9
Pics 6-9

Pics 6-9
Forum: Car Audio and Multimedia 04-02-2012, 02:41 PM
Replies: 2
Views: 9,142
Posted By slimak9
DIY: W140 Bose Stock Amp with an Aftermarket Deck

This is a follow up to my post:
http://www.peachparts.com/shopforum/car-audio-multimedia/315180-trying-sound-w140-putting-all-my-gathered-info-into-1-post.html

1992-1993 Bose Beta II System
...
Forum: Car Audio and Multimedia 03-28-2012, 02:59 PM
Replies: 0
Views: 3,240
Posted By slimak9
Exclamation Trying for sound in a W140. Putting all my gathered info into 1 post...

Hello,

I have a 1993 W140 which requires some stereo work. I would like to get it back as close to factory, but without going back to the Becker 1432 head unit.

Currently an after market head...
Forum: Tech Help 03-09-2012, 06:21 AM
Replies: 5
Views: 1,575
Posted By slimak9
Thumbs down Interior Rear Lights won't come on with switch

W140
1993 300SD

When I hit the switch in overhead dome light unit to turn on the rear interior lights, only the 1 center light turns on. The 2 side reading lamps do not. These 2 side reading...
Forum: Tech Help 03-01-2012, 06:54 AM
Replies: 4
Views: 5,118
Posted By slimak9
Pefect. The smaller relay of the two has seem to...

Pefect. The smaller relay of the two has seem to do the trick. The ABS light has been off for a few trips now. (There was a Black & Silver Relay under the black plastic cover). I changed the silver...
Forum: Tech Help 02-28-2012, 01:57 AM
Replies: 4
Views: 5,118
Posted By slimak9
Can anyone plz tell me where the ABS Solenoid Valve Relay (A7/3k1) is located??

1992 300SD W140

Had the ABS light come on within a few metres of driving. Then would come on everytime the car was started until I disconected the battery. Then would come on again within a few...
Forum: Tech Help 02-11-2012, 03:06 AM
Replies: 2
Views: 2,263
Posted By slimak9
Trunk opens randomly by itself on W140 S350

I've searched for a solution, but couldn't find any solutions.

1995 S350 Turbo Diesel

When I start the vehicle it will randomly on random occasions pop the trunk open. This model has the trunk...
Forum: Tech Help 10-04-2011, 01:33 PM
Replies: 2
Views: 2,104
Posted By slimak9
Should the guide rail in the left/drivers side...

Should the guide rail in the left/drivers side block #29 be replaced?

Since I would need to remove the front timing cover for that job I would also change the tensioner guide rail. If I proceed...
Forum: Tech Help 10-04-2011, 04:30 AM
Replies: 2
Views: 2,104
Posted By slimak9
Unhappy of course I get to change the 1 timing chain guide rail that 'never breaks'

1992 400SE M119.971

Engine Dies After Cold Start on Accel./Decel.
TSB: DDAF05_20-U-6400FA
Date:01/27/1999

After much research into a dying engine, I pulled the valve covers to examine the...
Forum: Tech Help 06-14-2011, 08:13 PM
Replies: 17
Views: 5,035
Posted By slimak9
I did change it to Volts 20 on the digital...

I did change it to Volts 20 on the digital multimeter. I checked that it was working correctly by hooking up the battery leads & at idle got 16.2 Volts.

Is this >0.3V suppose to be present at the...
Forum: Tech Help 06-14-2011, 07:35 PM
Replies: 17
Views: 5,035
Posted By slimak9
With my luck I'm probably measuring that wrong...

With my luck I'm probably measuring that wrong too.

But what really puzzled me, is I left the Camshaft position sensor disconnected & tried to start it. It cranked a second or two longer & started...
Forum: Tech Help 06-14-2011, 07:26 PM
Replies: 17
Views: 5,035
Posted By slimak9
I can honestly say I don't think I'm measuring...

I can honestly say I don't think I'm measuring the insulation reaistance correctly.

I did one more test from ALLDATA which said to test voltage at the Camshaft Position Sensor while at idle...is...
Forum: Tech Help 06-14-2011, 05:03 PM
Replies: 17
Views: 5,035
Posted By slimak9
I figure I'd post the resistance readings...

I figure I'd post the resistance readings measured from B5 (Ground, Camshaft position sensor) on the 8-pin connection on the ICM to the other 6 grounds on the ICM.

This is my ICM layout. Thanks...
Forum: Tech Help 06-14-2011, 04:26 PM
Replies: 17
Views: 5,035
Posted By slimak9
Ok so I believe I've been measuring everything...

Ok so I believe I've been measuring everything correctly now.

I read the resistance of the wire between the signal connection at the Camshaft sensor and A2 Ground terminal (the connection that...
Forum: Tech Help 06-14-2011, 12:15 AM
Replies: 17
Views: 5,035
Posted By slimak9
This is under Electrical Specification on...

This is under Electrical Specification on ALLDATA:

CAMSHAFT POSITION SENSOR
Sensor resistance 900 - 1600 Ohm
Insulation resistance >200 kOhm

And yes, my electrical knowledge is limited,...
Forum: Tech Help 06-13-2011, 09:23 PM
Replies: 8
Views: 1,973
Posted By slimak9
Jim, How did you find and test for the...

Jim,
How did you find and test for the "memory-bit" failure inside the DI Module? Is this the same as the Ignition Control Module?

I have code 6 (Camshaft Position Sensor) which is constantly...
Forum: Tech Help 06-13-2011, 08:44 PM
Replies: 17
Views: 5,035
Posted By slimak9
porkface, It could be a cheap seonsor, I called...

porkface,
It could be a cheap seonsor, I called MB today and it was $270 here in Canada :eek: Special order too!
The one by Facet I bought was only $37 from a US supplier.
Is there any way to test...
Forum: Tech Help 06-12-2011, 02:48 PM
Replies: 17
Views: 5,035
Posted By slimak9
Exclamation can't cure camshaft position sensor issue.

1992 400SE W140

After clearing all my fault codes, these 2 codes returned:
Distributor Ignition (Socket 17)
Code 6 - Camshaft position sensor
Code 8 - Transmission overload switch does not...
Forum: Tech Help 05-06-2011, 01:34 PM
Replies: 0
Views: 1,773
Posted By slimak9
Exclamation pre & post facelift W140 interchangeable body parts?

1992-1994 Pre - Facelift
1995-1999 Post - Facelift

I'm scouting for W140 front fenders, hood and front bumper for a 1993 W140 and came across a mechanically dead 1995 W140 for a great price.

I...
Forum: Tech Help 05-04-2011, 08:32 PM
Replies: 1
Views: 836
Posted By slimak9
Anti-theft Alarm System pulse code 15?

1992 400SE
W140

I'm getting a pulse counter code 15 when I test the ATA system (pin 23), but on the fault code table there is no DTC Readout for 15. Anyone know what this is for? I can't clear...
Forum: Tech Help 05-04-2011, 08:25 PM
Replies: 1
Views: 1,166
Posted By slimak9
Exclamation SRS codes won't clear, but no SRS while driving

1992 400SE

I checked for any codes in the various W140 pulse counter systems.

I cleared all the codes in the many systems to see which return, but once I got to the SRS (pin 30) I got these...
Forum: Tech Help 04-07-2011, 11:59 AM
Replies: 4
Views: 1,246
Posted By slimak9
Unfortunately I'm not in the USA nor have a US...

Unfortunately I'm not in the USA nor have a US credit card, I tried registering for this site a while back. It looks like a very useful tool to have, but it wouldn't allow me to register.

I...
Forum: Tech Help 04-07-2011, 05:06 AM
Replies: 4
Views: 1,246
Posted By slimak9
2 sizes of fuel filter...which do I need? W140

I'm trying to order a fuel filter for a 1992 400SE and I can't figure out which of the two sizes I need. This is what it reads on all of the parts sites:

1ST OPTION
Optional 002 477 13 01 can...
Forum: Diesel Discussion 04-05-2011, 08:18 PM
Replies: 5
Views: 2,609
Posted By slimak9
W140 Engine Swap: 1993 300SD Engine into a 1992 400SE Body?

A driver decided to play bumper cars with me on the road and so he ran a red light totaling my 1993 300SD. :mad: Luckily I wasn’t injured and I was at no fault.

I was struck on the left front...
Forum: Car Audio and Multimedia 09-16-2010, 08:02 PM
Replies: 0
Views: 1,243
Posted By slimak9
question about Soundgate XR4 into W140 with new Deck HU.

I'm putting in a new deck HU into a 1993 300SD and want to bypass the tuner which is shot, but I want to keep the original Bose amp, which I just had rebuilt.

I've been reading over the fantastic...
Forum: Tech Help 08-22-2010, 12:25 PM
Replies: 11
Views: 3,378
Posted By slimak9
Fred, that is a good question. Nothing has been...

Fred, that is a good question. Nothing has been done to the car in 8 months while in storage. I ran fine when put into storage and now I can say it runs better.

Maybe someone more experienced...
Forum: Tech Help 08-21-2010, 02:20 PM
Replies: 11
Views: 3,378
Posted By slimak9
The CPS arrived. I also ordered a Fuel Pump Relay...

The CPS arrived. I also ordered a Fuel Pump Relay ($16) at the same time, which on many forums was talked about also being the cause of a no start or intermittent shut off.

I hooked up the CPS and...
Showing results 1 to 30 of 121
Page 1 of 5 1 23 Last »

 
Forum Jump


All times are GMT -4. The time now is 12:12 AM.

Contact Us - Mercedes-Benz Discussion Forum - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page