PeachParts Mercedes-Benz Forum

		PeachParts Mercedes-Benz Forum > Search Forums
Search Results

Showing results 1 to 20 of 20
Search took 0.01 seconds. Search: Posts Made By: Wired_Bob

Forum: Diesel Discussion

09-17-2010, 08:24 PM

Replies: 8

Blower motor problems....

Views: 1,268

Posted By Wired_Bob

Check the brushes for wear. Mine acted that way....

Check the brushes for wear. Mine acted that way. Closing the door might start the blower working and a few miles later it would stop. Gave all the indications that the control circuits were at...

Forum: Diesel Discussion

08-31-2010, 10:42 PM

Replies: 34

changed delievery valves, and now getting air in lines all the time on injector 2and3

Views: 3,462

Posted By Wired_Bob

Today It started the car. It runs but with a bad...

Today It started the car. It runs but with a bad knock and vibration. There didn't seem to be any metallic sounds coming from the pump. I let it run and loosened the hard line one at a time to...

Forum: Diesel Discussion

08-29-2010, 11:13 PM

Replies: 34

changed delievery valves, and now getting air in lines all the time on injector 2and3

Views: 3,462

Posted By Wired_Bob

I did lift out the bottom 1/2 of the delivery...

I did lift out the bottom 1/2 of the delivery valve. How can I get it back where it should be?

Forum: Diesel Discussion

08-29-2010, 02:00 PM

Replies: 34

changed delievery valves, and now getting air in lines all the time on injector 2and3

Views: 3,462

Posted By Wired_Bob

That is a big relief. I thought there were...

That is a big relief. I thought there were moving parts that it would grind or break. Thanks for your help. Robert

Forum: Diesel Discussion

08-29-2010, 02:23 AM

Replies: 34

changed delievery valves, and now getting air in lines all the time on injector 2and3

Views: 3,462

Posted By Wired_Bob

When I had the assembly open I removed the round...

When I had the assembly open I removed the round part with the slotted pin (where the spring sets). The instruction I had said to put the washer under the valve. I put under the parts I had...

Forum: Diesel Discussion

08-29-2010, 02:02 AM

Replies: 34

changed delievery valves, and now getting air in lines all the time on injector 2and3

Views: 3,462

Posted By Wired_Bob

I wish it were that easy. The instructions I got...

I wish it were that easy. The instructions I got to install, was to put them under the valve. I tried. The first time one disappeared I thought I had accidently flicked it out. I put in another...

Forum: Diesel Discussion

08-29-2010, 12:08 AM

Replies: 34

changed delievery valves, and now getting air in lines all the time on injector 2and3

Views: 3,462

Posted By Wired_Bob

I just went through the oring replacement with my...

I just went through the oring replacement with my OM603 (300SDL). You mentioned a problem I'm now having. I lost the crush washers in the IP. (Long story and stupid) How did you get them out? ...

Forum: Tech Help

10-21-2007, 09:26 AM

Replies: 0

87 300SDL headlight washer problem

Views: 764

Posted By Wired_Bob

87 300SDL headlight washer problem

I have a problem with the washer fluid siphoning out of the tank, Once the washer is activated. Just replaced the pump.:o No change. Can not find a reference to a anti-siphoning valve or any...

Forum: Diesel Discussion

01-24-2007, 08:24 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

Weather has been cold and I have been working...

Weather has been cold and I have been working till after dark. Since this problem isn't mission critical I haven't gone any farther. The answer to amp question is .8 Ohms. I got this by figuring that...

Forum: Diesel Discussion

01-22-2007, 11:46 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

Disconnected trunk light. Found trunk light...

Disconnected trunk light. Found trunk light wires. Pulled wires from channels it was routed through. Looked and touched as much wire as I could pull out. Found one wire that had been scuffed. Thought...

Forum: Diesel Discussion

01-21-2007, 05:42 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

Done. Still no change.

Done. Still no change.

Forum: Diesel Discussion

01-21-2007, 02:40 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

Today I tested the circuit again. This time with...

Today I tested the circuit again. This time with digital meter. The reading between the spring contact point and a ground was .2 Ohms. I unplugged the antenna power plug in the trunk and tested the...

Forum: Diesel Discussion

01-20-2007, 09:58 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

Digital meters can be confusing. My analog meter...

Digital meters can be confusing. My analog meter i was using was an old inaccurate Amprobe my father gave me 20 years ago. He was Mercedes mechanic in his day. This getting off the subject but,...

Forum: Diesel Discussion

01-20-2007, 09:41 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

I'll do that tomorrow and check resistance to...

I'll do that tomorrow and check resistance to ground at the spring contact point to confirm the result. I have been using an analog meter so far. Tomorrow I bring out the digital meter for a more...

Forum: Diesel Discussion

01-20-2007, 09:19 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

Yes. That was my thoughts. I didn't put a fuse...

Yes. That was my thoughts. I didn't put a fuse in to watch it go poof but, that would have been my prediction. I did carefully use a probe to momentary make contact between the fuse contact...

Forum: Diesel Discussion

01-20-2007, 08:45 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

In retrospect I should have checked the...

In retrospect I should have checked the continuity and resistance between the spring contact and a good ground for a more accurate reading.

Forum: Diesel Discussion

01-20-2007, 08:40 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

With the fuse removed, The red probe (+) of the...

With the fuse removed, The red probe (+) of the meter touches the bottom fuse contact point. The black probe (-) contacting the upper (spring) contact point, The meter reading was about 13.25 volts. ...

Forum: Diesel Discussion

01-20-2007, 04:44 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

Thanks for the reply.:) If it had only been that...

Thanks for the reply.:) If it had only been that easy. Removed and unplugged assembly. Checked voltage across fuse # 15. Still battery voltage. Any suggestions? Anybody?:confused:

Forum: Diesel Discussion

01-19-2007, 10:48 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

I hope the repair is that simple. I can check...

I hope the repair is that simple. I can check that tomorrow. What is trick to remove the light and switch without ruining the headliner?

Forum: Diesel Discussion

01-19-2007, 09:49 PM

Replies: 23

Electrical problem with 87 300SDL

Views: 2,180

Posted By Wired_Bob

Electrical problem with 87 300SDL

Have shorted circuit on fuse 15. This is one that has antenna, dome lights, and courtesy lights. Thought problem was with alarm system. Unplugged module with no change. Only clues to this mystery is...

Showing results 1 to 20 of 20

Forum Jump

All times are GMT -4. The time now is 02:11 PM.