Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Search Forums
Reload this Page Search Results
Register ShopForum Gallery FAQ Calendar Search Today's Posts Mark Forums Read

Page 1 of 17 1 2311 Last »
Showing results 1 to 30 of 500
Search took 0.10 seconds. Search: Posts Made By: nulu
Forum: Tech Help 06-30-2022, 09:18 PM
Replies: 2
Views: 79
Posted By nulu
c 36 rings

I believe CP pistons in california can get the correct rings for you
Forum: Mercedes-Benz SL Discussion Forum 06-12-2022, 08:24 PM
Replies: 1
Views: 126
Posted By nulu
560 intechange

What is the difference between a 560 sl 5.6 vrs a sedan 560 sel 5.6 , can i swap the sedan motor into a convertible?
Forum: Mercedes-Benz SL Discussion Forum 06-06-2022, 03:42 PM
Replies: 2
Views: 305
Posted By nulu
i had a friend with same contamination , after...

i had a friend with same contamination , after filters fluid and radiator replaced , it was stll shifting hard took about a month then shifts smooth as silk
Forum: Tech Help 06-05-2022, 10:44 AM
Replies: 12
Views: 419
Posted By nulu
Is the fuel pressure from pump to fuel...

Is the fuel pressure from pump to fuel distributor good? you have an accumulator at the rear of the car if the diaphragm is leaking internally ie bypassing pressure you need to check that too, FUEL...
Forum: Tech Help 05-23-2022, 12:03 PM
Replies: 39
Views: 1,312
Posted By nulu
fuel pump

looking up your car , i found a wiring diagram 126.024 your car designation s class with a 6 cylinder reading via pin id of fuel relay= pin 4 = starting valve ie when car cold it gets the starting...
Forum: Tech Help 05-20-2022, 08:46 PM
Replies: 2
Views: 286
Posted By nulu
replace the starter and relay both common or just...

replace the starter and relay both common or just relay
Forum: Tech Help 05-19-2022, 11:20 AM
Replies: 2
Views: 293
Posted By nulu
battery drain

look in the electronics box at right front shock area, inside there is a module called mulitfunction module, there is a k - 40 relay, pse pump in right rear etc , use an amp meter , inductive to...
Forum: Tech Help 05-14-2022, 01:17 PM
Replies: 39
Views: 1,312
Posted By nulu
The fuel relays is what controls shutdown, only...

The fuel relays is what controls shutdown, only primes system until it gets crank signal then keeps running as long as it's getting a signal,if you want to see if your getting pressure bridge relay...
Forum: Tech Help 05-12-2022, 10:45 AM
Replies: 39
Views: 1,312
Posted By nulu
ok so you have ruled out likely not ignition, it...

ok so you have ruled out likely not ignition, it will run with shot glass of fuel , next as soon as key turn to on the pumps should ren for a couple seconds , your not getting that?
Forum: Tech Help 05-11-2022, 09:42 AM
Replies: 39
Views: 1,312
Posted By nulu
Lightbulb Ok just to be clear, when the key is turned to...

Ok just to be clear, when the key is turned to run the fuel relay will turn the pump on to prime the fuel system, then shuts off. Then while cranking and getting the crank signal allows the pump to...
Forum: Tech Help 05-08-2022, 01:45 PM
Replies: 39
Views: 1,312
Posted By nulu
When it wont run, do you have spark from the...

When it wont run, do you have spark from the center distributor cap coming from the coil?, it should jump a 1/4 gap, care full dont shock yourself
Forum: Tech Help 05-08-2022, 01:35 PM
Replies: 39
Views: 1,312
Posted By nulu
if the relay pin number 30 and pin 87 are...

if the relay pin number 30 and pin 87 are jumpered it has to run the pumps if not you have wiring or pump short or wire short , for the pump to run with relay in you need a couple of pins with power,...
Forum: Tech Help 04-30-2022, 03:10 PM
Replies: 39
Views: 1,312
Posted By nulu
no power to fuel pumps

Another possibility is ovp relay , and or td signal to fuel relay may not always be there , monitor the td signal , when a freinds sl560 had similiar problem i used
two volt meters , one to ezl...
Forum: Tech Help 03-02-2022, 10:42 PM
Replies: 683
Views: 105,057
Posted By nulu
Bought an E 320 e wagon 1994 EX ROADSIDE CAR ...

Bought an E 320 e wagon 1994 EX ROADSIDE CAR for 19,000 in 1997 had 99,000 miles on it now 234,000 only thing broken was alternator at 140k , and thermostat broke at 120k still own it, putting in...
Forum: Tech Help 01-12-2022, 09:05 PM
Replies: 19
Views: 976
Posted By nulu
This year 2021 my e 320 wagon egr failed too ,...

This year 2021 my e 320 wagon egr failed too , and no longer available, i found a similiar one off a newer engine , but it didnt bolt on, so i removed the guts and they did bolt on to my valve base...
Forum: Tech Help 01-06-2022, 09:34 PM
Replies: 2
Views: 483
Posted By nulu
differentials last a long time, practically...

differentials last a long time, practically indestructable
Forum: Tech Help 01-06-2022, 09:27 PM
Replies: 5
Views: 527
Posted By nulu
i have a mbz factory manual set and the tool to...

i have a mbz factory manual set and the tool to remove the rockarms , and a 560 sl engine sitting in my garage i need to get rid of
Forum: Tech Help 01-01-2022, 08:33 PM
Replies: 2
Views: 429
Posted By nulu
that means move cylinder 1 crank counter weight...

that means move cylinder 1 crank counter weight out of the way of the oil pan when it gets removed , it may collide with oil pan when pan removed , so it would be positioned cylinder 1 , 90 degrees
Forum: Mercedes-Benz Performance Paddock 12-25-2021, 12:33 PM
Replies: 4
Views: 596
Posted By nulu
diesel crank

i have a diesel crank , was going to make my n 104 a 3.6 , but ended up buying a complete AMG3.6 out uf a 1995 c 36, let me know if you want it, pm me
Forum: Tech Help 12-19-2021, 08:35 PM
Replies: 15
Views: 1,022
Posted By nulu
i went for the obvious, replace the loose right...

i went for the obvious, replace the loose right rear bearing , even the brake pads were wearing uneven, but noise still there , then also replace left rear and noise gone, stethoscope dosent work...
Forum: Tech Help 12-16-2021, 09:41 PM
Replies: 15
Views: 1,022
Posted By nulu
yes, but on my 94 wagon the bearing was opposite...

yes, but on my 94 wagon the bearing was opposite of expected side left turn ( NOISE WAS LESS)unloading left side noise diminished, but turned out to be the right side, however the wagons have roller...
Forum: Tech Help 12-05-2021, 02:14 PM
Replies: 15
Views: 1,022
Posted By nulu
The factory tool wouldnt release the wheel...

The factory tool wouldnt release the wheel flange from the bearing, if it did , then i could
of used the other tool to remove the bearing from the spindle, normal on a sedan 124 ball bearings allow...
Forum: Tech Help 12-02-2021, 10:02 PM
Replies: 15
Views: 1,022
Posted By nulu
Your not going to change the rear bearings with...

Your not going to change the rear bearings with out a hydraulic press, its best to remove whole flange/spindle and take to a machine shop let them do it , even with the factory tools mine wouldnt...
Forum: Tech Help 11-29-2021, 09:11 PM
Replies: 15
Views: 1,022
Posted By nulu
then try a stethescope on my 94 124 wagon one...

then try a stethescope on my 94 124 wagon one side was slightly loose , i replace that bearing , but noise still there, ended up changing both noise now gone
Forum: Tech Help 11-29-2021, 10:38 AM
Replies: 15
Views: 1,022
Posted By nulu
get the rear wheels off the ground , see is...

get the rear wheels off the ground , see is either wheel has excess play, if you can tell which side is making the naise go around a curve (UNLOADING) the side that nakes noise may help...
Forum: Tech Help 10-18-2021, 09:57 PM
Replies: 9
Views: 681
Posted By nulu
To find a single bad lifter, use a feeler gauge...

To find a single bad lifter, use a feeler gauge maybe .010 and try to find a "loose " fitting rocker arm might need thicker or thinner gauge, slip it between cam and rocker arm
Forum: Tech Help 10-16-2021, 10:36 AM
Replies: 9
Views: 681
Posted By nulu
That is 100% lifter noise, check your cam or...

That is 100% lifter noise, check your cam or lifter rockers for excessive wear
Forum: Mercedes-Benz Used Parts For Sale & Wanted 10-11-2021, 12:13 PM
Replies: 5
Views: 648
Posted By nulu
the motor has had a valve job and double row...

the motor has had a valve job and double row chain semi rebuilt, was installed into a 123 chassis 4 door, and have a 560 sl motor was going to put it in place of 380 till the car got t boned
Forum: Mercedes-Benz Used Parts For Sale & Wanted 10-10-2021, 10:48 PM
Replies: 5
Views: 648
Posted By nulu
i have a complete380 sl motor in my garage i need...

i have a complete380 sl motor in my garage i need to get it out , im in los angeles
Forum: Tech Help 10-06-2021, 10:52 AM
Replies: 5
Views: 752
Posted By nulu
first replace crankshaft sensor

first replace crankshaft sensor
Showing results 1 to 30 of 500
Page 1 of 17 1 2311 Last »

 
Forum Jump


All times are GMT -4. The time now is 04:07 PM.

Contact Us - Pelican Parts Mercedes-Benz Catalog - Archive - Privacy Statement - Terms of Service - Top

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2022, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page