Can someone tell me where these wires go?
 

The dome light does not come on when i open the drivers side door,it does light for the pass. door. I pulled the door switch and it is o.k there is no power from the two wires.I checked all fuses and they are o.k.I looked under the dash,but could not find them. Any help would be appreciated.

probably your seatbelt hazard relay, which is behind the speedo cluster, which must be removed. That worked for me in my w124.

Can i asume that the cluster must come out?

004 545 08 32 is the light control module locate under left side panel next to the couise control module.

MB STARS I removed the panel under the steering wheel and i can see the two wires go into a black rubber sheeth and run up into the dash board. I can not find the light control modual. Is it near the O.V.P ?

Is under driver side remove lower panel look up at near brake padle there is a silver box (cruise control ) and a small black box with wire plug at buttom that is your light relay. (not the two wires coming from the driver side door)

MB Stars,
Is that module only for the 420 sel, or is there also one there for a w124?

MB STARS If it works on pass. side and not on the drivers side,is the control box bad,and should i replace it?

Can someone help me hear?

There is a diode open in the seat belt module. Can be repaired easy enough.

Steve: Please explain in simple terms,since i am electronicly chalanged.

Anybody!