|
|
|
|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
another head related Q- I followed the torque specs on the CD but found they were..
different for the head gasket kit. I of course didnt see this until after I ran the car. The CDs say 55NM then 90 degrees x2. The head gasket kit says 70Nm then 90 x2. Should I be concerned over 15 Nm? I dont want to tighten them more since I already ran the engine.
this is a 103 engine, 1992 300TE Last edited by belagirl; 08-29-2004 at 11:13 PM. Reason: edited |
#2
|
||||
|
||||
Assuming you're talking about an M103, there's some debate on that. The MB manual for the 126 series says 70 Nm plus 90* twice. The MB manual for the 201 and 124 series says 55 Nm plus 90* twice. AFAIK, it's the same engine.
Sixto 95 S420 87 300SDL |
#3
|
|||
|
|||
I wouldn't worry at all!
MY MB literature shows 70nm for the M103 engine, & 55nm for 102/104 engines as the STARTING torque.
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
Bookmarks |
|
|