Car: 1985 300TD Wagon.

On the rear hatch is the washer pump nozzle which in my car does not work. I looked this weekend at removing it and replacing the water line becuase I found a hole at the hinge to the hatch.

I could figure out how to remove the nozzle, what is the best method?

Thanks for you time, Jason

I figured it out...remove the panelling and close the hatch. From the inside you will see a little phelps screw holding the nozzle in place. Remove it. The nozzle should be pulled out to the passenger-side because of the way it is hooked in...

The tech manual is a good thing, just sometimes difficult to find info in especcially for the T sedan folks....