I recently purchased a 93 190e. The drivers door lock does not unlock. It locks (with key) correctly. I suspect a bent linkage somewhere inside the door. Can some one provide me with a detailed explanation as to how to remove the 201 door panel? I had the benefit of the same from a forum user in regards to my 88 560 and it was of great benefit. My search has come up empty however for the 190. Thanks so much!

__________________
Woody

One of the 190Revolution members did a write up with pictures here:

http://www.190revolution.net/forum/viewtopic.php?t=11890

Going from memory here....

Unscrew the door lock pin.
Unscrew the bolt holding in the plastic trim piece at the rear of the door.
Remove trim piece.
Pry off the seat switch buttons and the platic cover underneath them.
Un-seat the rod from the inner door release handle. You'll need something to pull on the rod to create some slack. I've also done this after loosening the door panel.
Door panel should be ready to come out. Push up on the bottom of the door panel and work your way up slowly.

Thanks folks...took the panel off yesterday. Thanks for your help!

__________________
Woody