|
|
|
|
|
#1
02-10-2005, 10:28 AM
|
|||
|
|||
|
300 SE no start
I have a 1988 300SE, about 2 months ago the car was having stalling problems at traffic light, but after cranking, it would start again, then after about doing this 5 or 6 times it stopped on the road and will not start at all.
I have replaced the coolant temp sensor on it, along with a new fuel filter, new distributor cap and rotor, and finally a crankshaft position sensor. when I removed the line going to the cold start injector and crank the engine, there is fuel coming out of that port on the fuel distributor, however when I do the same on another line going to any of the 6 fuel injectors, no fuel comes out of the respective port while cranking. I am wondering of I have a stuck plunger in the fuel distributor. any help is appreciated. 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 300 SE Won't Start For Nothing! | Benster Tom | Tech Help | 1 | 12-14-2004 08:11 PM |
| 1990 300SEL Cold Start Problems | Qrash | Tech Help | 7 | 11-09-2003 02:02 PM |
| Replaced intake manifold gasket and now won't start - 300 SDL | tstarr | Diesel Discussion | 0 | 11-04-2003 08:11 PM |
| 420 SEL does not start at all. Checked OVP, Cold Start Valve, replaced Check Valves | xsohaib | Tech Help | 7 | 12-12-2002 11:25 AM |
| Drove 78 300 SD 123K 300 miles yesterday wont start today | juan | Tech Help | 2 | 03-20-2000 11:28 PM |
Threaded Mode
