|
|
|
#1
|
|||
|
|||
Can anyone tell me how to get to the shifter bushings on a 86 300E. Might have already asked this question once before.I don't remember the answer. Thanks
__________________
Richie 1986 300E |
#2
|
|||
|
|||
Check out http://www.DELSINGMOTORSPORT.COM for some aftermasrket shifter bushings. These are for manual tranny only.
Dave |
#3
|
||||
|
||||
There are two of them, about a dollar a piece. You have to get them from the bottom.
__________________
J.H. '86 300E |
#4
|
|||
|
|||
Richie,
I just replaced mine. From under the car remove the spring clip on the shifter end. On the trans end, remove the link from the trans(13mm nut?)and slip linkage assembly from the car. Press new bushing on the shift lever side and remove the spring clip from the trans link and press in new bushings.Reassemble the trans link back onto the shifter linkage and reinstall into the car. JD Hawthorne '86 300e |
#5
|
|||
|
|||
Excuse the ignorance, but what are these for exactly?
|
#6
|
|||
|
|||
They are bushings between the automatic gear selector lever, the shifter control rod and the transmission. They break down and fall out due to heat/age. You can still select gears ok, but you will hear a extra "clacking" noise when you do so.
JD Hawthorne '86 300e |
#7
|
|||
|
|||
Thank J.D.,
You explained pretty clear how this is done.Thanks for the reply.
__________________
Richie 1986 300E |
#8
|
|||
|
|||
93' 300E?
Will these procedure also work for a 1993 300E 3.2L? Thanks!
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1989 300E Shifter Interlock?? | mfullington | Tech Help | 3 | 03-25-2011 10:57 PM |
1994 C280 Shifter bushings | bainjs | Tech Help | 8 | 01-12-2005 08:54 PM |
Sluggish shifter mechanism 87 300E | DanielW | Tech Help | 2 | 07-19-2003 01:01 PM |
240D Shifter Problems--almost got me flattened on Highway | Carrameow | Tech Help | 0 | 07-14-2003 02:11 PM |
'86 300E - Shift Linkage Bushings | Phalcon51 | Tech Help | 1 | 02-24-2003 02:51 PM |