![]() |
|
|
|
#1
|
|||
|
|||
why does my uni-wiper keep jumping out of the groove? 87 300E
Whenever I turn my wipers on, after a few swipes, the wiper jumps out of and on top of the grooves that it is supposed to swipe into (black pieces that run up the side of the length of the windshield). It then proceeds to be loud and obnoxious and smack these black pieces with every swipe. It also leaves a big unwiped space in the center of the windsheld when it does not go into these grooves. What's going on here?
I might need a new wiper motor, because the speed of the wiper fluctuates depending on how fast the engine is revving. Could this somehow be the culprit? Thank you for your time.
__________________
headrivenoise... listen. |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rebadging '87 300e | emr0591 | Detailing and Interior | 6 | 09-04-2007 09:12 AM |
Where's the intermittent wiper relay in '90 300E? | mikey-az | Tech Help | 1 | 08-09-2002 03:17 AM |
advice for replacing wiper switch? | stuttgart | Tech Help | 1 | 11-06-2001 05:11 PM |
Headlight wiper misaligned - 86 300e | LarryO | Tech Help | 4 | 08-18-2001 12:46 PM |
HEADLIGHT WIPER broken on 89 300E | mermaid | Tech Help | 2 | 08-10-2000 08:39 AM |