|
|
|
#1
|
|||
|
|||
Help-oil gauge is Maxed out on my 190E-16V
Can someone please tell me why my oil gauge goes all the way to the max when ever I start my car? what could be wrong? I am afraid to drive it, which would cause damage to the engine.
|
#2
|
||||
|
||||
Is this a new occurance? Usually the oil pressure gauge does max out on startup and while on the gas, but slips down, perhaps 1 Bar, while idling after warm.
|
#3
|
||||
|
||||
Rest easy...
...an oil gauge pegged to the max indicates a faulty oil pressure sending device...when it goes bad, the needle goes to "3" simply by turning the ignition on...even without starting the engine. Unless you've suffered catastrophic engine damage recently, your oil pressure is just fine. I had to replace mine on my W124 last year for the exact same symptom. Since it's a different engine I can't tell you exactly where it's located...but it's goes for around $70 and is about a 15 minute DIY swap.
__________________
2009 ML350 (106K) - Family vehicle 2001 CLK430 Cabriolet (80K) - Wife's car 2005 BMW 645CI (138K) - My daily driver 2016 Mustang (32K) - Daughter's car |
#4
|
|||
|
|||
Thank you guys!! I recently just purchased the car. I have been wanting this car for a long time, now I finally able to buy it, I really want to keep it in as best shape as possible.
Just in case, if it doesn't drop off after warmed up, then what? |
#5
|
||||
|
||||
If the gauge is functioning properly, don't worry about it. I doubt the engine would really hold over 3.0 bars of pressure when fully hot at idle.
__________________
Ali Al-Chalabi 2001 CLK55 1999 Dodge Ram 2500 Cummins Diesel 2002 Harley-Davidson Fatboy Merlin Extralight w/ Campy Record |
#6
|
||||
|
||||
What the hell temperature is the temp guage reading?
__________________
Andrew 300e 294,000mi 380sel 185,998mi 380se 309,980mi |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oil Change DIY Instructions | Limited Edition | Off-Topic Discussion | 5 | 09-23-2007 10:56 AM |
The oil debate again What do you think of this | dpbrowne | Diesel Discussion | 101 | 04-01-2005 02:33 PM |
Oil Pressure Gauge - pegged when ignition 'ON' and engine is off - 95 E320 | 71Rcode | Tech Help | 4 | 03-07-2004 02:36 PM |
Foreign and Domestic Oil no longer needed... | moparmike | Off-Topic Discussion | 5 | 09-04-2003 08:13 PM |
190E front hub bolt patterns: 190E 2.3 vs. 190E 16v | haasman | Tech Help | 5 | 04-02-2003 04:29 PM |