I have '81 300D with 722.118 AT and would like to check the Working, Modulator, and Govenor pressure (as sugguested by the ATSG manual) before I start tearing into the transmission itself.

Where can I get pressure gauges to test transsmision?

If I have to make something rather than buy something, what are the thread sizes?

If I construct something, it will likely be have fittings in Inches --- where can I get Metric to Inches conversion fittings?

David

Use a banjo fitting and bolt. At the end of the banjo fitting you can attach a plastic pressure line. Make sure the plastic tubing is rated for at least 250 psi.

__________________
'82 300SD - 361K mi - "Blue"

"Good judgement comes from experience. Experience comes from bad judgement."

listen, look, .........and duck.

I am having a difficult time finding a 8mmx1.0mm metric fitting .
Any sugguestions?

(10mm are easy to find, but no one has a 8mm)

David

Go to any NAPA part store, they have a KD brand oil pressure gauge with fittings for the MB pressure taps.