|
|
|
|
|
#1
08-08-2005, 04:55 PM
|
||||
|
||||
|
Best way to repair stripped exhaust stud?
I had an engine noise that sounded like a lifter but only under throttle and it was too loud to be a lifter. I found a loose exhaust bolt but it wouldn’t take the torque. The stud is spinning in the bore at about 35 ft/lbs. It is holding for now but I know it won’t hold very long.
What is the best way to repair this? Does the head or motor have to come out? I imagine removing the manifold and drilling the head to fit an insert. This one is going to be fun. 
__________________
Steve 1985 Mercedes 500SL Euro (Gray market) 1995 BMW 520i Euro (Gray market) 1992 BMW 525it Wagon 1994 Honda Del Sol Si 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Broke a exhaust stud | guage | Diesel Discussion | 35 | 05-11-2016 05:29 AM |
| Finished replacing Exhaust Sytem on 300D | Capt Kirk | Diesel Discussion | 2 | 01-27-2002 11:02 PM |
| What is the best way to position exhaust system on car? | Steve190E 2.3 | Tech Help | 3 | 01-23-2002 12:56 PM |
| Need Exhaust Manifold for 82 240D | JimSmith | Diesel Discussion | 1 | 01-12-2002 12:43 PM |
| How to locate and exhaust manifold/pipe leak? | JRBrown | Tech Help | 2 | 05-23-2000 06:54 PM |
Threaded Mode
