Hey all,

I am going to be swapping a good used engine (under warrenty) for a lady into her tired 5-speed 190E. Do I need to know anything special about this job? Labor cost?

I'll be doing it over this weekend so any advice would be great. If anyone has a link to another thread (I did some searching but direct swap across threads are few) that would be excellent.

Thanks!

unhooking all the hoses and wires. they are old and brittle, ..and when you start pulling keep looking areound for that hose or wire that you forgot to unhook! otherwise, it sholdnt be a problem.

tom w

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

I assume you have a good "balance beam" for your hoist so you can tilt the engine/trans severely as it comes out/goes in.

__________________
Chuck Taylor
Falls Church VA
'66 200, '66 230SL, '96 SL500. Sold: '81 380SL, '86 300E, '72 250C, '95 C220, 3 '84 280SL's '90 420SEL, '72 280SE, '73 280C, '78 280SE, '70 280SL, '77 450SL, '85 380SL, '87 560SL, '85 380SL, '72 350SL, '96 S500 Coupe

I love the Peter Egan tip: Put a big post-it note over the ignition switch that says "Hey Stupid, Did You Remember To Put the Oil Back In?"

Since you'll have the engine out, I would replace the motor mounts and consider re-doing the firewall insulation. Change the shifter bearings in the shifter assembly as well.

a brand new rebuilt caddy motor for my 52. we eased it down into the car, and after several beers and lots of swearing started it up. i kept saying "hey! the oil light is on! " finally i shut it off, thankfully, and after milling around a bit i checked the oil. ooops! no oil. my buddy then started pouring oil into the water hose fitting that sticks out the top of the old caddy motors (course, couldn't wait til i had water in it to fire it up). i said "hey numb nuts, (or words to that effect) that is the water thingie!". i then realized that he had been drinking rum and coke while i was drinking the beer. and he was worse off than i was.

luckily when my buddy rebuilt the motor he used really good white lithium grease and we did no damage.

after that i refrained from mixing alcohol and mechanics work. this was back in about 1989. or so.

'course, now i rarely mix alcohol and anything.

tom w

__________________
[SIGPIC] Diesel loving autocrossing grandpa Architect. 08 Dodge 3/4 ton with Cummins & six speed; I have had about 35 benzes. I have a 39 Studebaker Coupe Express pickup in which I have had installed a 617 turbo and a five speed manual.[SIGPIC]

..I also have a 427 Cobra replica with an aluminum chassis.

Yeah, it's a typical situation, you spend hours getting the thing in and buttoned up and that's when the "testosterone poisoning" kicks in and all you want to do is hear the thing crank . . .

A good pre-start checklist is a lifesaver. I'm sure many of us have fallen victim to the unbolted ground strap . . .