CSI injector fittings
 

I'm trying to make my own injector tester using a pressure regulator and a fuel resorvoir. I have no idea where to get a fitting that will connect to a US 1/4 pipe thread to a Bosch injector. Does anyone know what this type of fitting is called and where I might be able to get one.

John Roncallo

Where ever quality epoxy is sold. :)

Well actually the idea is to be able to remove the injector and install it back in the car once it is tested.

I did find a web sight the sells metric to inch convertion fittings

http://www.adaptall.com/F-MetricConversion-brass.htm

but I am not sure I jnow if these are correct or what sixe I need.

Does anyone know what BSP, BSPT, BSPP or a JIC is? Are any of these the fittings that will thread on to a Bosch CSI injector?

J. Roncallo

the size of the fitting is 12mmx1.5 pitch

What I did was to remove one of the injector-FD lines, use a tight-fit rubber hose to connect the FD end flare to my pressure-testing rig, secure with a hose clamp, then screw on the injector.

Steve

I have been thinking of that. But I sure would like to get something a little more production like.

J. Roncallo