|
|
|
|
|
#1
03-14-2001, 06:51 PM
|
|||
|
|||
|
I recently rpaird the vacuum door lock system on my 83 240D. The check valve was dead in the engine compartment, and one line was misrouted from when I reinstalled engine fter rebuilding. The system was working 1/2 fine--it only worked when car was running, not after motor stopped.I was going to finish fixing in springtime when i got warmer.
Also, the other day, the passenger door refused to lock, and I had to pull the vacuum lines from the rubber 4 way connectors in the floor to bleed it. There was still quite a bit of vacuum there. Are my lines misrouted? Do i have to adjust the door vacuum switch? I hate messing with Mercedes trim, I'm scared of scartching it!!! 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AC system repair on 1980 240D | jcj | Tech Help | 6 | 01-19-2004 06:45 PM |
| 83 240D Vacuum system doesnt work--Vacuum element failure in doors? | Carrameow | Diesel Discussion | 1 | 02-18-2003 12:28 AM |
| 240D condition update and GP relay question | engatwork | Diesel Discussion | 5 | 01-29-2002 12:36 AM |
| 240d AC question | Jaclson | Diesel Discussion | 3 | 01-17-2002 08:22 AM |
| short in the glow system 240d | kcn | Diesel Discussion | 10 | 11-16-2001 08:17 AM |
Threaded Mode
