![]() |
|
|
|
|
|
LinkBack | Thread Tools | Display Modes |
#1
|
|||
|
|||
Help! - 86 420SEL Idle misfire after timing chain guide replacement
Hi Folks,
Well got the car running, however, Idle is not so good. Feels like rapid misfire - (high frequency) at idle. Off idle engine runs fine. Power seems okay - I think. I may be paranoid and it may be down as well. Off idle the engine seems smooth. -no misfires. Full throttle no misfires. Everything I did is as follows. Guides Tensioner Spark plugs Ign Wires Belts Cam Oilers v. cover gaskets. The spark plugs are Bosch Super WR8DC+ gaped at .032 thousands. I lost time when replacing the guides. Spun the motor by hand and the pistons and valves were interfering. So I removed the rockers and retimed motor. I don't know if this is a problem but when I got the crank and the right cam lined up to marks the left cam is now 1/2 tooth retarded. Before I began the repairs I set the motor up at TDC and all marks lined up. I don't know what changed - why I now have the left cam 1/2 tooth off. Ran compression test all cylinders on left side were at 160 psi. The right side was 165 - 175. Can anyone give me an idea. Is the spark plugs the resistor type and causing the problem? or do I have a valve timing issue? or something else? Thanks, Joe Last edited by jodeven; 12-31-2006 at 01:49 PM. Reason: correct title |
Bookmarks |
|
|