W210/ 1996 Ignition Cylinder Lock Replacement HELP!!!!!!!!!
 

I got into my car this afternoon, put my key in, and couldn't turn it! I thought the steering wheel was locked, so i jiggled it... DID NOTHING. I kept lightly jiggling the key and finally it started. Then it happened again, when I went into the car this evening. It is getting difficult to turn the ignition...

So here goes- Does anyone know, or reccomend a way to replace the ignition cylinder lock? Will i need to replace the dashboard? Do i need any special tools? Any advise is greatly appreciated! I see that the part is not all that expensive... I hope it is something i can tackle in an hour or two!

Thanks Guys!
Michael

1996 E320/ 102,000 miles/ Weiss
1996 E320/ 100,000 miles/ Gruhn
1992 300SE/ 204,000 miles- STOLEN!
1989 560SEL/ 135,000 miles- SOLD
1989 260E/ 72,000 miles- SOLD
1985 300SD/ 272,000 miles- SOLD
1993 300E 3.2/ 82,000 miles- SOLD
1993 300E 2.8/ 136,000 miles- SOLD

There is a "special tool" to remove the black ring around the tumbler.

When the key is at position 1 you push-in on the black ring & turn 1/4 turn counter clock-wise. Then you pull the key, tumbler, & the black ring off.

Takes less than 10 minutes with the correct tool.