|
|
|
|
|
#1
06-17-2001, 08:55 PM
|
||||
|
||||
|
Need some help with my A/C blower.
No matter where I set the 'volume' wheel (Min, AUTO, Max) it blows a very low volume of air. As the control is rotated from one end (Min) to the other (Max), the air volume changes but it's blowing at what would be considered a MIN setting. The A/C is fine; compressor cycles and the evaporator temp ranges from 34F to 40F, so it's blowing very cold air but just not a lot of it!! The sensors (internal temp and external temp sensors seem ok based on the readings of the using the DIAG mode (my page; menu #14)  Poked around and it seems to be this 'critter'. What is it?? Looks like a triac? But that's for AC? I'm confused? Thanks in advance for any help. 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Low pressure valve A/C on 96 E320 | bjafari | Tech Help | 1 | 07-09-2004 09:36 AM |
| What should high & low side pressure be for A/C? | Ron Brooks | Tech Help | 4 | 07-05-2003 02:39 PM |
| Bad odor from A/C and Refrigerant leakage | Holson Adi | Tech Help | 5 | 01-17-2003 02:00 PM |
| Need A/C pressures High and low for a 91 300E 3.0 | DIYBenzer | Tech Help | 0 | 01-30-2002 09:15 PM |
| A/C low pressure compressor cut-off | gkimbrough | Tech Help | 5 | 05-12-2000 06:52 PM |
Threaded Mode
