PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/index.php)
-   Tech Help (http://www.peachparts.com/shopforum/forumdisplay.php?f=1)
-   -   blew lots of white smoke!!! (http://www.peachparts.com/shopforum/showthread.php?t=207870)

NickyStreets 12-12-2007 04:01 PM

blew lots of white smoke!!!
 
i changed my alternator today so i flushed my radiator since i had to dissconect it anyway. everything went fine until i let the car warm up and took it for a ride around the block. i lot of white smoke was comming out of my exhaust but only for 2 blocks then it stoped and the car runs fine. temp is just over 80..idle oil pressure is 1.5.WHATS THE DEAL!?

RBYCC 12-12-2007 05:04 PM

Quote:

Originally Posted by NickyStreets (Post 1701913)
i changed my alternator today so i flushed my radiator since i had to dissconect it anyway. everything went fine until i let the car warm up and took it for a ride around the block. i lot of white smoke was comming out of my exhaust but only for 2 blocks then it stoped and the car runs fine. temp is just over 80..idle oil pressure is 1.5.WHATS THE DEAL!?


Leaking head gasket is typical of white smoke.
Leave your radiator cap off, let the engine come up to temp ( thermostat open ) and see if you have bubbles in your water.
That would indicate gasket breach in the water jacket.
If the water looks oily could indicate breach oil to water jacket.

DeaconD 12-14-2007 06:05 PM

possible head gasket????
 
:confused: does anyone know about how much a head gasket job is??? blowing lots of white smoke when I first start her up in the morning, or after shes been sitting for awhile? looked at engine oil and it looks a little pasty. :mad:

nissanzx1 12-14-2007 06:27 PM

Deacon D--straight six head job should be $1100+ IF the head isn't warped... Find a good shop that will set you up with a 60 Day+ warranty... On my '91 300E, I also had to replace the radiator at an additional cost of over $150:(

Good Luck,

-GH

DeaconD 12-14-2007 07:38 PM

my wife was right about the cost! :o LOL Its not overheating or anything yet, but I need to get it done quickly before it starts affecting the cooling. :(


All times are GMT -4. The time now is 07:45 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website