Control Pressure Cable screw adjustment?
Can someone tell me the correct way to adjust the automatic transmission's control pressure cable screw (pictured below) on a '92 190E 2.6?
Thanks!!!! [IMG]http://i243.photobucket.com/albums/f...tanza/knob.jpg[/IMG] |
MB suggests that the adjustment allow for 1mm of play where the bellcrank for the cable meets the throttle linkage.
ON that photo just below the fuel line. |
Thanks! So I remove the rubber boot and see that the cable inside has 1mm lateral movement left and right (not front to back)? Someone else has siad adjust it so it is neither tight nor loose. I guess it's about the same thing. Thanks again!!
|
I can't see the picture on your post, but mine had a plastic pointer you were supposed to align. At the end of the day, though, I adjusted mine to where it shifted about where I liked it.
|
All times are GMT -4. The time now is 03:25 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website