|
|
|
|
|
#1
07-15-2001, 12:33 AM
|
||||
|
||||
|
Today I replaced the plugs on my recently purchased 85 380se (121k mi.) because after fixing the fast idle problem (thanks guys), it idles normal but now misses. I replaced the distributor cap and rotor. I noticed that the gap in the old plugs were quite wide,so I went ahead and replaced them w/ bosch supers. Slight change to worse resulted. Were these plugs set at the factory or did I need to regap them? I noticed on some threads, some of you went wider than spec, why? I will check your answers before buying new wires but they seem fine. (no arcing) Slowly but surely building a beauty!
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bosch Platinum+4 Spark Plugs | rsmcmahon | Tech Help | 14 | 07-02-2005 10:19 PM |
| Possible HUGE issue: MB dealers issuing potential problem spark plugs, rough idle | ericgr | Mercedes-Benz SL Discussion Forum | 1 | 09-24-2004 08:33 PM |
| Bosch Spark Plugs for 280SEL 6CYL | M_Anker | Vintage Mercedes Forum | 23 | 02-27-2004 11:56 AM |
| Some versions of Bosch Platinum plugs O.K. for Mercedes engines | suginami | Tech Help | 41 | 07-20-2003 09:45 AM |
| Beru vs. Bosch - Spark Plugs | Zeus | Tech Help | 10 | 02-16-2001 09:09 AM |
Threaded Mode
