Anybody know how to R & R the top moulding on a W124?
That's the moulding that runs from the bottom of the windshild to the rear of the top.
Thanks.

Do you mean the molding inside the car or on the outside?

__________________
I'd rather argue against a hundred idiots, than have one agree with me. — Winston Churchill

I mean the grey/black moulding running on the top of the car.
Thanks.

It's held on by little pastic clips. Easy to break. Easy to bend. Start at the rear.

__________________
2012 E350
2006 Callaway SC560

Thanks

If you have the service manual, it's job #88-855. If you would like, I can email you the pdf. I'm not sure how to post it here. It's basic but I think the pictures will help because they are easy to break.

__________________
I'd rather argue against a hundred idiots, than have one agree with me. — Winston Churchill

hi Savas, i might be doing the same job on my car pretty soon, would you mind sending me the pdf too at poncy_cancio@yahoo.com, TIA

Sent!

__________________
I'd rather argue against a hundred idiots, than have one agree with me. — Winston Churchill

thanks george for the pdf

Hi, Savas . I'm also need it,would you mind sending me the pdf too at
3starion@gmail.com
and do you know how to remove side moulding door W124 300E because I want to check inside area if there is some rusty area,thanks a lot

I could use this as well...thanks in advance!

jetpilot72@hotmail.com

__________________
Sam
1989 Mercedes 300E