PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/index.php)
-   Tech Help (http://www.peachparts.com/shopforum/forumdisplay.php?f=1)
-   -   2002 C240 Tranny Problem!!!!!!!!!help (http://www.peachparts.com/shopforum/showthread.php?t=213110)

BigRed0803 02-08-2008 12:12 AM

2002 C240 Tranny Problem!!!!!!!!!help
 
My car will not shift out of first gear, also it will not shift over where I can manually shift gears from drive with my slap stick gear shifter? When I shift out of part into reverse or drive it goes into gear violently. I am pretty handy and got a rebuilt transmission and installed it but the problem is still happening. Anyone have any idea what it could be?

redcoupe 02-08-2008 12:13 AM

The shifter is most likely your problem. Did you get it wet right before the problem happened?

qwkstang50 02-08-2008 12:15 AM

your trans is in limp mode. codes need to be cleared or you may have a problem with module.

Johnhef 02-08-2008 12:38 AM

Did you really replace the transmission without checking fault codes first???

I agree with above, it sounds like a bad shifter module.

BigRed0803 02-08-2008 09:20 AM

I had car checked for codes today by a friend and my car has a code in it P0702 transmission electrical system malfunction or something to that nature. Does that narrow it down for anyone out there? What kind of job is the shifter module that seems to be my problem from the feedback I am getting? Thanks alot.

ILUVMILS 02-08-2008 01:16 PM

:confused: Before you waste any more money, check to see if the transmission control module is full of ATF.

BigRed0803 02-09-2008 12:02 AM

I have replaced the transmission control module.

BigRed0803 02-09-2008 12:05 AM

I replaced the transmission because when I pulled the pan off there was lots of shavings in the pan. Do I need to have the computer reset now? Does the code stay in the system, could I have fixed the problem and the code still be in the car's computer?

Johnhef 02-09-2008 12:18 AM

yes, reset the codes and reset shift adaptations as well.

C32AMG 02-09-2008 05:34 AM

Quote:

Originally Posted by BigRed0803 (Post 1757582)
I have replaced the transmission control module.


Did you buy a new coded TCM for your vehicle and transmission, used TCM will not work unless coded.

ILUVMILS 02-09-2008 08:39 AM

Quote:

Originally Posted by BigRed0803 (Post 1757587)
I replaced the transmission because when I pulled the pan off there was lots of shavings in the pan.

Did you flush the transmission cooler? If there were metal shavings in the pan, you can be sure there's some in the cooler as well.

Johnhef 02-09-2008 01:40 PM

same goes for the torque converter- was it replaced?


All times are GMT -4. The time now is 12:59 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website