|
|
|
|
|
#1
07-31-2001, 02:30 PM
|
|||
|
|||
|
W126 window problem (not sliding jaw)
My 1983 300SD drivers side window goes up to about 3/4 of an inch then stops and makes the clunk-clunk noise. I then have to pull it up manually. To go down I have to push it back to the 3/4 point where it will take it down but clunk-clunks at the bottom. Took door panel off, both sliding jaws are ok, sliding and not broken.
Could this be the teeth on the window regulator or power motor? Thanks
__________________
1993 Mercedes Benz 300D 2.5 205K (ex wife's) 1984 Mercedes Benz 300SD 320K (SOLD) 2004 Mercedes Benz C240 75K 1995 GMC Sierra 2WD 5.7L 188K 1983 Mercedes Benz 300SD 239K (SOLD) 1987 BMW 325i 220K (SOLD FOR SALVAGE) 609 Certification 
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PEEN or DRILL window sliding jaw | mattsuzie | Tech Help | 13 | 12-19-2008 04:29 PM |
| W126 window went down but won't go up! | jp233 | Tech Help | 20 | 01-09-2005 01:08 PM |
| W126 rear window design flaw. | Hatterasguy | Diesel Discussion | 10 | 01-08-2005 06:04 PM |
| Window problem: window won't move | qb320 | Tech Help | 2 | 12-25-2003 05:12 PM |
| W126 300SD Rear quarter window | TCCBass | Diesel Discussion | 3 | 01-25-2002 05:42 PM |
Threaded Mode
