|
|
|
#1
|
|||
|
|||
Power steering fluid
My '88 420SEL is VERY slowly leaking power steering fluid, it starts to groan when I turn the wheels every two or three months or so. My mechanic installed a kit to stop the leaking, but I almost doubt that he did anything, because the problem's come back.
Anyway, my question is, is the a serious problem, or should I just keep adding fluid as needed? And, how do I know how much fluid there should be? I don't see any markings on the inside of the resevior (I don't really know what to call it). I bought MB power steering fluid, I just need to know how much to add. Thanks alot for any help. |
#2
|
|||
|
|||
You can just keep adding fluid if you don't mind the mess and it will be alright. It's not that expensive to reseal the pump or gear if thats what it takes to remedie the problem.
|
#3
|
||||
|
||||
Check the condition of your low pressure return hose. You may find that over the years the hose has begun to break down and is seeping the fluid through the hose. Do you have a fender well that is wet with steering fluid?
The return line on mine is held in place with small hose clamps, since it isn't a pressure line that is OK. I simply replaced the return line using 19/32 (I think??) crankcase ventilation line. Make sure the hose you use is rated for petroleum products, heater hose will not work. http://www.peachparts.com/shopforum/showthread.php?threadid=3455&highlight=handy+little+tip Check the link for further details.
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. Last edited by MikeTangas; 08-14-2001 at 12:56 AM. |
#4
|
|||
|
|||
Is it possible to add too much fluid though? Or should I just fill it to the top?
|
#5
|
||||
|
||||
There should be a mark or a line stamped into the body of the reservoir approximately 3/8 from the top. Fill to that line and you'll be full. Allow the level to drop too low and you will start sucking air into the system. If that happens the steering will make all sorts of noise and the fluid will appear pink and frothy.
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. |
#6
|
|||
|
|||
Thanks alot.
|
#7
|
|||
|
|||
Big Pimpin,
Don't want to ask the obvious, but has the P/S filter been changed? I had a similar problem on my 88 300E. Filter replacement and new fluid did the trick. Marks88 |
#8
|
|||
|
|||
I assumed that was done at the 120k mile service, but if it acts up again, I'll look into that. I added more fluid, and it works great now. Thanks.
|
#9
|
||||
|
||||
Now to locate where the fluid is going. Since replacing the return hose and resealing the gearbox last year I have not had to add one bit of steering fluid.
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. |
#10
|
|||
|
|||
OK. . .I changed my PS fluid last weekend and attempted to replace the filter. How do you get the %$*@* out? I unscrewed the stem/spring nut but it will not back off and it seems that the whole shaft just turns. I gave up.
Any ideas? |
#11
|
|||
|
|||
The filter lifts straight out.
|
#12
|
||||
|
||||
And as I recall, I had to use 2 screwdrivers to actually pull it out.
__________________
2006 E350 w/ 155k miles (Daily Driver) Previous: 1993 300E 3.2L Sedan w/ close to about 300k miles 2003 E500 Brilliant Silver (Had 217k miles when totalled!) 1989 300E with 289,000 miles (had for <1 yr while in HI) 03 CLK 500 cabrio (Mom's) 2006 C230k (Dad's) 1999 S420 (Mom's/Dad's) 2000 C230k Sport sedans 2001 CLK320 Cabrio (Mom's) 1995 C280 My First Mercedes-Benz... (155k miles. EXCEPTIONAL AUTOMOBILE. Was Very hard to let go of!) |
#13
|
||||
|
||||
At the bottom of the reservoir is a plate with a series of holes in it. That is the "steady plate". Just hook a small screwdriver or two into the holes and lift the plate straight up. The filter resides under the steay plate.
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. |
#14
|
|||
|
|||
I'm guessing we're talking about different setups. There is a shaft that runs up through the filter which has a white plastic sleeve which is about 1/2" in diameter. It is much bigger than the center hole in the filter. That sleeve rides on a spring that goes through the filter and into the nether regions of the ps pump. There is a small nut which is threaded onto the shaft that holds the sleeve and spring in place. This sleeve/spring is what places upward pressure on the reservoir lid. To put the lid on, you have to press down so that the cap nut will thread onto the shaft and enable the lid to seal to the reservoir. Does this make sense?
Essentially, there is no way to simply lift out the filter without removing the sleeve...and the entire shaft turns when I attempt to remove the nut holding the sleeve/spring in place. Maybe I'm overlooking something obvious. Thanks, Mike |
#15
|
||||
|
||||
OK. Mine has a steel sleeve over the spring, but it is not retained by any nut. Once the lid is off, the sleeve and spring simply pull up, then the steady plate etc. I cannot say if the 300E should have a nut retaining everythin inside. perhaps one of the E owners can chime in.
Have you owned the car since new? If not perhaps the PO added a little something extra to hold the innerds in place. Can you push down on the sleeve enough to see the unthreaded portion of the rod below the nut? If so, try to gently get on that portion with a small set of vise grips to hold the rod steady while removing the nut.
__________________
Mike Tangas '73 280SEL 4.5 (9/72)- RIP Only 8,173 units built from 5/71 thru 11/72 '02 CLK320 Cabriolet - wifey's mid-life crisis 2012 VW Jetta Sportwagon TDI...at least its a diesel Non illegitemae carborundum. |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Power steering fluid leak (w210) | edl100 | Tech Help | 16 | 11-29-2011 10:00 AM |
Wrong fluids in the brake system. | ericnguyen | Tech Help | 17 | 04-01-2005 07:31 PM |
w210 '97 E300 Power Steering Fluid | michakaveli | Tech Help | 4 | 08-20-2004 05:03 PM |
Power Steering Fluid | afmcorp | Tech Help | 1 | 01-16-2004 12:30 PM |
Power Steering fluid level | Doug Vazquez | Tech Help | 2 | 08-23-2000 09:02 PM |