|
|
|
|
|
#1
08-15-2008, 09:05 PM
|
|||
|
|||
|
95 c280 auto door lock
Ok my 95 c280 I took the inside locks and all apart to repair a dent.Well It was more than I could handle so it went to the body shop well the dents fixed.Ok but all the door locks work with the key outside except with the central dash switch my door does not work all the others work.So I took the door panel off found a screw missing compaired with the other side by the yellow vacum line in the door, replaced it,screw was inside door frame.Now the handle is better but the central switch does not work at all what did I do wrong.
 I checked everything twice I'm missing something.Thanks
|
|
#2
08-16-2008, 03:29 PM
|
|||
|
|||
|
ok did not know to press the reset button on ac now all doors work except driver and fuel panel door.Took apart door again guess the cable is streched could cause door not to lock with switch.How about the fuel door lock anyone mess with that.
|
|
#3
08-18-2008, 09:36 AM
|
|||
|
|||
|
C-280 door locks
No, but I have the same car and I have to lock/unlock all the doors with my trunk lock. It seems that the driver's door lock cylinder is either broken or some linkage fell off. The key will just spin around in the lock and not do anything.I have never tried removing the door panel to check this. Is it hard to do? If I can get the panel off, tell me what I should be looking for.
Also, when I activate the system using the trunk lock, the driver's door will lock, but not unlock. I then have to manually open the left passenger door and pull the driver's door lock button up to open it. Go figure! This is a great car- I have owned it since 1999 and have 171k on it- but it is full of "gremlins!"
|
 |
| Bookmarks |
|
|
Linear Mode
