![]() |
1994 - E420 Window problem
Hi All,
I've 1994 Merc. E420. Recently, Rear passenger side window went down and would not come up. When I press button, it gives me some noise, which means motor is ok so I think regulator is broke or damaged. I tried to open the door panel but don't know where to start. :confused: Please help. Thanks in advance |
You start with a search!
I searched on "W124 rear door panel" Found this: http://www.peachparts.com/shopforum/showthread.php?t=114912&highlight=w124+rear+door+panel Good luck! |
I had the same problem on my 93. It turned out that the gray plastic piece at the end of the cable snapped off and I couldn't seem to glue it back together with anything--even PC-7.
I checked with the dealer and they said they only sell the whole regulator as a unit, which I think was in the $400 range. I hardly ever use the back windows anyway, so I took a piece of 3/4" PVC pipe and wedged it under the window with the pipe slightly bowed. I cut a 1/4" slot in the top of the PVC so the bottom of the window could rest and not shake loose. If I recall, I might have also safety wired the pipe so it wouldn't move. That was a number of years ago and I haven't even thought about it until reading your post. If you go this route make sure you disconnect the power to the motor. |
May I humbly suggest this thread...
http://www.peachparts.com/shopforum/showthread.php?t=205929&highlight=regulator Get a new regulator on ebay, it works fine. Rgds, Chris W. |
Thank you guys, that worked out great. Special thanks to Chris W for his step by step guide
|
Which regulator did everyone get? It looks like there are two different manufacturers. Mine broke today.
TIA |
I'm not sure if it's the regulator that broke. The cable I have is just hanging and not attached to anything.
|
Here is a picture of what's going on with my regulator. I don't think it's a total loss and can be fixed. Something is going on with the cable near the blue wheel, but I don't have a good one to compare with, unless I remove the good side. Anybody know? Thanks
http://i180.photobucket.com/albums/x...A/CIMG1701.jpg |
| All times are GMT -4. The time now is 01:14 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website