|
|
|
|
|
|
|
|
#1
|
|||
|
|||
|
w124 e420 stalls
hi All,
I have a 1995 E420, wierd things have been hapenning. Even since I changed the fan clutch and Radiator ( got Shredded) the car has been acting wierd. It starts normally, roars like any v8, runs for about 10 mins, feels like it is suffocating ( not enough gas) then turns off. Then if you try to start it, it wont start, it will start backfiring ( Loudly). If you leave it alone for about an hour and come to start it , it will start right away. No Engine Light. One thing i did notice when it was on in idle, and I felt it started to stumble, I thought I would give it some gas to see if it would correct it, but it just turned off, and wouldnt start for another hour. Even if I am driving, it will stall on me. One thing to Mention, I just Read the codes off the reader ( the main One) I got code 6 Which are idle speed control fault and Camshaft position sensor Defective. One other thing, Even if it starts running rough and I turn it off myself, It still wont turn on unless I wait 45 min-1 hour. I just scanned pins 4 and 7, no codes on them at all. One more point to meniotn, The ASR Light does come on sometimes, but goes away when i turn the car off then on, it comes on randomly, not everytime, and It did used to come on before I had this stalling problem. any ideas? thanks ![]() ![]() |
|
#2
|
|||
|
|||
|
What happens when you check the codes on 4 and 7?
|
|
#3
|
|||
|
|||
|
When i check those pins, it blinks ones only, so no stored codes.
|
|
#4
|
|||
|
|||
|
What do you get on pin 19?
|
|
#5
|
|||
|
|||
|
I havent checked that one, I will check it in the morning.
|
![]() |
| Bookmarks |
|
|