E320 diag codes
1995 E320 hesitates and runs rough. It has 180k. I changed the engine wiring harness about 3 years ago. I just put a new MAF sensor. My diag codes are.
code 10 Pin 8 4,13 Pin 14 2,5,11 I am going to put new non resister plug and coil to plug connectors in tomorrow. I dont think thats the problem. Its also coughs through the air box. I can here on acceleration. Please help. Dave |
Code 10 in the DM is relating to the mass air flow sensor
Codes 4 & 13 in the fuel ECU are also about the mass air flow sensor. code 5 in the EA is related to the brake lamp switch & most "likely" has caused the other 2 codes |
You may have some spurious codes. Try clearing the codes and reread them in a few days. See which codes reappear.
|
Can the new MAF sensor be bad? Should i try another? or can something else give me these codes?
Dave |
Try a search for the codes. They've been posted dozens of times.
Also try searching the posts made by Arthur Dalton. |
Was the replacement part a NEW Bosch unit OR a reman??
|
MAF was Meyle german replacement. I changed the plugs and plug connectors and what a big difference. But still a small hesatation about 2100 rpm on accelaration. I guess I had more than one problem. Just wondering maybe I should check the fuel pressure?. First ill wait and see what codes come back.
|
B/C the plugs and connectors made a big difference, I would now reset the memory on pin 8 to get back to mean . Then run it and look for further codes.
|
Not to hijack, but what is the proper NGK plug for the M104?
Autozoo sold me BKR5E (resistor), is the correct one BK5E? |
All times are GMT -4. The time now is 04:16 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website