PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/index.php)
-   Tech Help (http://www.peachparts.com/shopforum/forumdisplay.php?f=1)
-   -   190E 2.3 8V Iginition Timing (http://www.peachparts.com/shopforum/showthread.php?t=246237)

professor 02-26-2009 10:25 PM

190E 2.3 8V Iginition Timing
 
I don't know if what I did is correct or complete.
I moved the front balancer until the T mark was right on the pin that sticks out on the block. I then moved the ignition distributor and lined it up with the notch on its housing. When I turned the car on the T was spot on where I set it as I used a strobe light to look at it while set at ZERO degrees.
Was there anything else I needed to do? The car does backfire if I push on the throttle while in neutral. By the way, this a 1988.

mbdoc 02-27-2009 08:05 AM

The distributor has NOTHING to do with ignition timing.

Timing is set by the signal from flywheel & pre-set program in the ignition module (EZL).

Aligning the distributor is only to keep the ignition from cross firing at higher RPM's

professor 02-27-2009 11:02 AM

So now maybe I have a bad EZL since the car backfires and stalls a lot, what do you think?

professor 02-27-2009 11:42 AM

My other question from observation is that I noticed that the mark on the front balance wheel will drift if I moved the distributor adjusting nut; how come you say they are not related? (this is all at idle of course)


All times are GMT -4. The time now is 05:37 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website