|
|
|
|
|
#1
08-09-2009, 04:32 PM
|
|||
|
|||
|
'86 300e Distributor Drive Hub
Replaced the cylinder head on my '86 300e yesterday and was just a few minutes away from smelling exhaust fumes and discovered the rotor drive hub would not fit into the end of the new camshaft. (What a letdown) It was a larger diameter than the hole in the new camshaft. The bolt in the new cam is a larger diameter than in my old one. I need a hub with a smaller diameter but with a larger bolt hole inside. Any help in identifying what I need and a good place to get it would be greatly appreciated.
|
|
#2
08-10-2009, 08:06 AM
|
|||
|
|||
|
From any 1988 & later M103 engine
__________________
MERCEDES Benz Master Guild Technician (6 TIMES) ASE Master Technician Mercedes Benz Star Technician (2 times) 44 years foreign automotive repair 27 Years M.B. Shop foreman (dealer) MB technical information Specialist (15 years) 190E 2.3 16V ITS SCCA race car (sold) 1986 190E 2.3 16V 2.5 (sold) Retired Moderator |
 |
| Bookmarks |
|
|
Linear Mode
