|
|
|
|
|
#1
12-14-2001, 05:35 PM
|
|||
|
|||
How to open foglight assembly?
Hi,
I need to replace my foglight bulb of my 1998 E-320. I am able to open the small hinge door under the bumper. However, I couldn't detach or open the back of the foglight assembly in order to replace the bulb. Would anyone give me a direction on how to do so? I will really appreciate it very much. Thank you. Last edited by sdjumin; 12-15-2001 at 12:10 AM. 
|
|
#2
12-18-2001, 08:08 PM
|
|||
|
|||
|
The back of the fog lamp assembly is held in place by a torsional snap fit. To release it you should press on the lower beam which rotates and opens access to the back of the bulb.
The door in the lower panel is made in a cheap plastic (polypropylene which sells for about $0.30 per pound). When you rotate the knobs to open and close the door use a quarter and not a screw driver which may damage the knob. Good luck.
__________________
pat201
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| propped the center vents' door open | domchang | Mercedes-Benz SL Discussion Forum | 10 | 04-10-2007 08:57 PM |
| What open discussion did for me | pentoman | Site Feedback | 3 | 12-02-2004 09:15 PM |
| w210 foglight wiring | jago1244 | Tech Help | 4 | 11-12-2003 02:50 PM |
| Fs: W124 300e Right Headlight / Foglight Assy | bd37703 | Mercedes-Benz Used Parts For Sale & Wanted | 0 | 08-04-2003 02:12 PM |
| Engine light DTC codes? 1994 S600 Coupe | 600sleeper | Tech Help | 3 | 02-24-2003 05:28 PM |
Linear Mode
