Stuck up
 

Driver window on my 88 300TE, that is. I replaced the switch but the window wont move. I have a motor I can put in, but how can I get the old one out without lowering the window? Any help is appreciated. Thanks

you might wish to change your thread title. It seems as thought you are complaining about girls in High School. ;)

Perhaps "W124 drivers window closed, need to change motor"

Suggestion:
unbolt everything and drop it down. Slide the assembly off the window.
I know the rear is different, but I just replaced a rear assembly that was also stuck in the up position. No problem.

Hope this helps. Let us know what you figure out and share pics of you can.

Could try and unbolt motor without removing assembly. It is kind of tight but I did it on my passenger side without issue.

first make sure that the right rear window works as these are set up on diagonal circuits.if not check the fuse.124 bodies have been known to fray the wires in rear doors by the hinges.