|
installing ignition lock cyliner 1993 300E
I am trying to install lock cylinder,cover, housing, and swith on a 1993 300E. I have one day off a week, so I am trying to conquer this tomorrow. I would like any advice, warnings, or step-by-step procedures before I get started.
|
Ignition "Tumbler" (Mis-Named It's actually Leaves.)
Study Hall:
http://w124-zone.com/downloads/MB%20CD/W124/w124CD2/Program/Chassis/46-8110.pdf http://w124-zone.com/downloads/MB%20CD/W124/w124CD2/Program/Chassis/46-8010.pdf From: http://w124-zone.com/downloads/MB%20CD/W124/Index/Groups/46Steering.htm Plus,There are Umpity Zump Gadzillion posts on the subject in the Advanced Search: http://www.peachparts.com/shopforum/search.php?searchid=5143313 |
Good stuff!
Using the correct diameter very stiff wire is critical. |
you really need the ends of the wires to be at roughly 45 degree angles to disengage an internal "lock"
|
| All times are GMT -4. The time now is 06:16 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website