Quote:
Originally Posted by Kestas
The top mechanism won't work if the roll bars are in the up position.
|
Quote:
Originally Posted by vexed
Kestas is 100% correct, the soft top switch won't light because the roll bar is up and therefore the top won't move.
Have you pulled the rear seat out and listened to what happens when you try the roll bar switch. There is a another switch in the rear of the center console for the rear passengers. Also the roll bar is not actuated by the hydraulic fluid pump, I believe there are solenoids that raise/lower it.
You should have a code. Are the two switches by the rear axle in the right position?
|
I have the rear seat out but don't hear anything when trying to lower the roll bars. I tried reading the codes again from port 9 under the hood. I got a code 8 (Roll bar malfunction indicator lamp (E30)), cleared it and I just get 1 flash now which means there's no codes stored. Now the roll bar light comes on when I first start the car then goes off (normal?) but the damn roll bars still won't go down. The buttons to raise/lower the roll bars are always lit?
When trying to pull codes from port 2 under the passenger floor mat, I don't get any flashes at all, not even 1. The red soft top switch is always lit up but doesn't do anything when pressed.
02-09-2012, 09:46 PM
Threaded Mode
