SLS pump reseal, o-ring sizes?
I ready many thread, but none seem to mention the exact sizes needed. From what I have read there are three. One person used these sizes as the closest match possible:
3/32" cs - 2 1/8" ID 1/16" cs - 2 1/2" ID 3/32" cs - 2 1/2" ID But those are in inches. I was wondering if anyone had the measurements in metric. If not the above will probably work. But I would like to get metric if I can find a shop that happens to have them. Also does anyone recommend a type/brand to buy or should I consult the supplier? I would assume something oil and heat resistant. |
Just keep us updated with whatever you find please.
|
Will do! After doing the ball joints, I feel I can tackle anything now :)
|
I picked up the above sizes. The are Vinton, so they should be best for heat and petroleum interaction.
But I had to buy 10 of each! So when I am done and find out how good a fit these are (or not) I will keep a set and make available some kits with directions for those that can not source them or, like me, can only buy in larger quantities. I had planned on doing it tonight but might be going to an x-mas related event. And Saturday will be warmer, so I will work on this then when I also do my own alignment. I plan to also take some pics to post and for directions with kits. |
Pelican seems to sell one. I wonder which one it is of the three?
010-997-43-45-M22 Pelican Parts - Product Information: 010-997-43-45-M22 |
All times are GMT -4. The time now is 10:33 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website