Stalling update 300TE
 

Any idea on this stalling problem on a 1990 300TE guys….

Now I've replaced..

1.OVP
2.ECU Temp Sensor
3.Fuel filter
4.Fuel pump relay
5.Speed sensor (Back of speedo head)

The car runs ok from cold to hot and now appears to start stalling once the engine has been switched off and on again. The engine will tick over normally until the car is moved ,it will even stall if the car is in neutral and pushed a few feet backwards or forwards,this can greatly improved by removing the wires to the speed sensor.


Any help gratefully received

Simon AKA dasboot

I have how found that when I disconnect the runon micro switch the problem completely disappears?.