|
HELP
My 1997 E-420 was running in driveway, It died and has not started again. No codes, I purchased a new key from dealer. It turns over but will not start????:confused:
|
When it is turning over is the tach needle moving?
|
NO
|
First thing that comes to mind is the crankshaft position sensor. Not much to changing it out.
|
I'd second a crank position sensor. There's a decent DIY with pictures (specifically on the E420) at BW in the W210 forum. Part is not very expensive, either.
Good luck. |
Thanks guys Ill give it a try...
|
Be glad the car was in your driveway... My crank position sensor failed on Interstate. After replacement everything was normal.
|
Could ya walk to Beale St Jeff????
|
I am in Houston. Was living in Memphis when I made up my username.
|
cps
Installed CPS still wont start...Tach not moving...Any Ideas????
|
To help we need more details on how it acts and what you have done.
Things like .. battery voltage, grounds check, fuse checks ect |
Fuel pump relay. Can you pull cap off rail to see if you gave fuel pressure.
|
I have no fuel and no spark??????
|
I have no fuel and no spark????
|
Fuses and grounds OK....Acts better trying to start since I put cps on... PS: TJ is my hero...
|
| All times are GMT -4. The time now is 05:31 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2026, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website