need information 190e
 

Hi would any member have the a diagram for the 12 volt wiring locations for engine for K - Jetronic Had a burn out on the loom .Must find a wiring diagram for a 190e 1990 to rewire it . We have a new loom but dont know the location of the cables Thank you for looking

Here's chapter 15 - engine electrical

http://www.startekinfo.com/StarTek/outside/11832/Resources/201Create/PDF/30010.pdf

And here are the wiring diagrams

http://www.startekinfo.com/StarTek/outside/11832/Resources/201Create/PDF/01002.pdf

I think, however, if you just need to plug plugs then you're better off posting up a picture and I'm sure I can add labels to your picture / photo and say where each bit goes.

Stretch mate thats fine .This is for a friend on the other forum in the uk .I have told him to join this forum as soon as he can. Info is superb .Thank you again.

As it turns out I think I may have found a wiring fault with my M102.910 loom. I'm about to go and pull it out of the car and will be adding disaster photo's in this thread =>

http://www.peachparts.com/shopforum/restoration-projects-long-term-builds/341121-achtung-das-schweinhund-baby-benz-thread-64.html

loom
 

Stretch sorry for late reply .Your link was just what the doctor needed .My thanks to you again .Job done .

Glad to hear it