Got another Mercedes diesel. This is an 81 300d. Very very nice, my last one was worn out and this one has 125k miles and I think it's accurate due to condition.

I've felt with these before so I'm fairly knowledgeable about the typical issues. The 81 300d has no Bowden cable. Only uses vacuum. Previous owner had transmission shop install new modulator valve and it IS holding vacuum. I checked vacuum after the vacuum valve on top of valve cover that's controlled by throttle. Well it's about 20hg and drops to 10 with throttle full. I think it's supposed to be 15 to 0 with full throttle. I just got it 2 days ago so I haven't had a chance to change transmission filter try.

Now here's what it's doing. With vacuum hooked up it flares in all gears and slips very bad after 1st and I let off and goes into 3rd.

With vacuum disconnected (0 hg) flare is better from 3rd to 4th but 2nd is still pretty much non existent. I remember some spring kits for the valve bodies on these. Seemed like the were some issues with some springs breaking. Assuming the changed filter doesn't help am I missing anything? If I disconnect vacuum it should be like I'm accelerating full throttle from a stop so this should eliminate the vacuum valve on valve cover from causing the problems. Any other ideas?