Clutch pedal Problems
 

Sometimes when going to shift the clutch pedal right to the floor before I can put it in gear. So I have to lift it up and press it down again..... What causes this problem???? Slave cylinde rmaybe

Assuming its hydralic, I'd look at the slave for leaking and same with the master. Rebuilding the slave cly is pretty straight up, I'd replace the master cly though as they are a bit tougher to remove and and have a few more internals. Your kinda lucky in that it'll come right back up. Does it tend to slowly engage the clutch while sitting at a stop with car in gear? That and low pedal have been most of the problems I've seen over the years.



Joe